Soda Tab Buckles

 

Supply List:

Tabs off of pop can

Tweezers

Embossing ink

Embossing powder

Heat Gun

Hammer

Nail file or sand paper

 

1. Remove tab from old pop can.  Clean it.  Hammer down any sharp pieces with hammer.
2. Rough up the surface a little bit with a nail file or some sandpaper.
3. Use the tweezers and hold the tab, cover HALF of the tab with the embossing ink and then dip into embossing powder.
4. Use heat gun and heat the powder until melted.
5. Repeat on other half of tab.
6. Repeat steps 3-5 to get a more finished look.  You can also use UTEE if you prefer.
7. Let cool and slip onto your ribbon.

 

Go back to “Advanced Scrapbooking”

Home

 

Updated: 7/1/05 

DebDuzScrappin.com © 2005 2006 All rights reserved.  Debbie Weller
Do not duplicate or reprint in whole or in part without written permission.